Ball Sinker Mould Combo

Ball Sinker Mould combo – 7 cavities

1/4oz (7g)| 1/2oz (14g)| 1oz (28g)| 2oz (56g)| 3oz (84g)| 4oz (112g)| 6oz (168g)

Want to know how to make sinkers? Our Ball Sinker Mould Combo is great for making your own lead sinkers in 1/4-to-6-ounce sizes. Just check out the steps below. These sinkers are excellent for fishing rivers| estuaries| and bays. We are sinker mould suppliers in Australia.

The Ball Sinker Mould combo makes:

• 1 x 1/4 Ounce Sinker
• 1 x 1/2 Ounce Sinker
• 1 x 1 Ounce Sinker
• 1 x 2 Ounce Sinker
• 1 x 3 Ounce Sinker
• 1 x 4 Ounce Sinker
• 1 x 6 Ounce Sinker

OVERALL DIMENSIONS: 221mm wide x 47mm deep x 40mm high

WEIGHT: 897 grams

If you’re in need of pyramid sinkers| please visit https://adventureprimal.com.au/product-category/fishing-gear/sinker-moulds/

How to make sinkers:

1. Ensure you are wearing protective clothing and all care must be taken when heating and pouring lead.
2. Put scrap lead into saucepan and heat until molten (lead will normally melt at 650 degrees).
3. Once lead is molten use a cooking spoon to take away any impurities that have risen to the top.
4. Take your coat hanger wire (wire is only used when making sinkers that require a hole in the centre) and place within the mould.
5. Using the tongs grab tour mould carefully and have the pouring cavity facing you.
6. Pour molten lead into mould until cavity is full.
7. it is recommended the mould be preheated before use.
8. Once mould has been heated up and your lead is fully molten and clean you can proceed to pour the lead in to the cavity.
9. Wait 10 seconds and using pliers pull wire out then proceed to open mould.
10. Using your pliers snip the excess lead of the top of the sinkers.
11. Good luck and remember to always take care.
12. When disposing of unwanted lead please take note of your local authority about appropriate methods.

Warning:

1. Lead is a toxic material
2. Use PPE when handing moulds
3. Use dry moulds as water can cause molten lead to explode.