Snapper Sinker Mould Small

$64.95 incl. GST

SKU: AP-Mould-SnapSmall-AXP Categories: , Tag:

Free Delivery Australia wide. Please allow up to 30 days for delivery.

Snapper Sinker Mould Small are a great way to make your own sinkers for fishing shallow reef areas or low current locations.

 

Snapper Sinker Mould Small - 5 Cavities

1oz (28g), 2oz (56g), 3oz (84g)

Want to know how to make sinkers? Our Snapper Sinker Mould Small is great for making your own sinkers in 1 to 3 ounce sizes. Just check out the steps below. Suitable for shallow reef areas or low current locations. We are sinker mould suppliers in Australia.

This mould makes:

  • 2 x 1 Ounce Sinkers
  • 2 x 2 Ounce Sinkers
  • 1 x 3 Ounce Sinker

OVERALL DIMENSIONS: 99mm wide x 65mm deep x 31mm high

WEIGHT: 346 grams

For other moulds and equipment for fishing, go to https://adventureprimal.com.au/product-category/equipment-for-the-outdoor-enthusiast/fishing/

How to make sinkers:

  1. Ensure you are wearing protective clothing and all care must be taken when heating and pouring lead.
  2. Put scrap lead into saucepan and heat until molten (lead will normally melt at 650 degrees).
  3. Once lead is molten use a cooking spoon to take away any impurities that have risen to the top.
  4. Take your coat hanger wire (wire is only used when making sinkers that require a hole in the centre) and place within the mould.
  5. Using the tongs grab tour mould carefully and have the pouring cavity facing you.
  6. Pour molten lead into mould until cavity is full.
  7. it is recommended the mould be preheated before use.
  8. Once mould has been heated up and your lead is fully molten and clean you can proceed to pour the lead in to the cavity.
  9. Wait 10 seconds and using pliers pull wire out then proceed to open mould.
  10. Using your pliers snip the excess lead of the top of the sinkers.
  11. Good luck and remember to always take care.
  12. When disposing of unwanted lead please take note of your local authority about appropriate methods.

Warning:

  1. Lead is a toxic material
  2. Use PPE when handing moulds
  3. Use dry moulds as water can cause molten lead to explode.

Additional information

Material

zinc alloy

Type

Lead Sinker, FISHING SINKER MOULD

Mould Weight

346g

Snapper Sinker Weight

28g 56g 84g

Quantity

1pcs / lot

Reviews

There are no reviews yet.

Be the first to review “Snapper Sinker Mould Small”

Your email address will not be published. Required fields are marked *

0
    0
    Your Cart
    Your cart is emptyReturn to Shop