Snapper Sinker Mould Large

$89.95 incl. GST

SKU: AP-Mould-SnapLarg-AXP Categories: , Tag:

Free Delivery Australia wide. Please allow up to 30 days for delivery.

Snapper Sinker Mould Large is a great way to make your own sinkers for fishing deep reef areas or high current locations.

Snapper Sinker Mould Large - 5 Cavities

4oz (112g), 8oz (224g), 12oz (336g)

The Snapper Sinker Mould Large is great for making your own sinkers in 4-to-12-ounce sizes. Just check out the steps below. Suitable for deep reef areas or high current locations. We are sinker mould suppliers in Australia.

The Snapper Sinker Mould large makes:

  • 2 x 4 Ounce Sinkers
  • 2 x 8 Ounce Sinkers
  • 1 x 12 Ounce Sinker

OVERALL DIMENSIONS: 137mm wide x 132mm deep x 36mm high

WEIGHT: 1160 grams

For other moulds and equipment for fishing, go to https://adventureprimal.com.au/product-category/equipment-for-the-outdoor-enthusiast/fishing/

How to make sinkers:

  1. Ensure you are wearing protective clothing and all care must be taken when heating and pouring lead.
  2. Put scrap lead into saucepan and heat until molten (lead will normally melt at 650 degrees).
  3. Once lead is molten use a cooking spoon to take away any impurities that have risen to the top.
  4. Take your coat hanger wire (wire is only used when making sinkers that require a hole in the centre) and place within the mould.
  5. Using the tongs grab tour mould carefully and have the pouring cavity facing you.
  6. Pour molten lead into mould until cavity is full.
  7. it is recommended the mould be preheated before use.
  8. Once mould has been heated up and your lead is fully molten and clean you can proceed to pour the lead in to the cavity.
  9. Wait 10 seconds and using pliers pull wire out then proceed to open mould.
  10. Using your pliers snip the excess lead of the top of the sinkers.
  11. Good luck and remember to always take care.
  12. When disposing of unwanted lead please take note of your local authority about appropriate methods.

Warning:

  1. Lead is a toxic material
  2. Use PPE when handing moulds
  3. Use dry moulds as water can cause molten lead to explode.

Additional information

Material

zinc alloy

Type

Lead Sinker, FISHING SINKER MOULD

Snapper Sinker Weight

112g 224g 336g

Quantity

1pcs / lot

Mould Weight

1160g

Reviews

There are no reviews yet.

Be the first to review “Snapper Sinker Mould Large”

Your email address will not be published. Required fields are marked *

0
    0
    Your Cart
    Your cart is emptyReturn to Shop