Pyramid Sinker Mould

$104.95 incl. GST

SKU: AP-Mould-Pyramid-AXP Categories: , Tag:

Free delivery Australia wide. Please allow up to 30 days for delivery. 

The Pyramid Sinker or star sinker excels in strong currents with any bottom condition, especially so in beach surf conditions. The pyramid tends to bury itself if the bottom is soft. On hard bottoms, the flat sides will prevent the pyramid from rolling with the current.




DIY Fishing Pyramid Sinker Mould - 5 Cavities

1oz, 2oz, 3oz, 1.5oz, 2.5oz

Want to know how to make sinkers? Our Pyramid Sinker Mould and brass eye set is great for making your own sinkers in 1 to 3 ounce sizes. Just check out the steps below. This pyramid sinker mould makes five different sizes and weights of pyramid sinkers at the same time. Mould folds in half to make three dimensional sinker in a triangular shape. Ideal for use when fishing the surf.. We are sinker mould suppliers in Australia.

The brass eyes are also sold separately in packs of 150 pieces. Go to

How to make sinkers:

  1. Ensure you are wearing protective clothing and all care must be taken when heating and pouring lead.
  2. Put scrap lead into saucepan and heat until molten (lead will normally melt at 650 degrees).
  3. Once lead is molten use a cooking spoon to take away any impurities that have risen to the top.
  4. Take your coat hanger wire (wire is only used when making sinkers that require a hole in the centre) and place within the mould.
  5. Using the tongs grab tour mould carefully and have the pouring cavity facing you.
  6. Pour molten lead into mould until cavity is full.
  7. it is recommended the mould be preheated before use.
  8. Once mould has been heated up and your lead is fully molten and clean you can proceed to pour the lead in to the cavity.
  9. Wait 10 seconds and using pliers pull wire out then proceed to open mould.
  10. Using your pliers snip the excess lead of the top of the sinkers.
  11. Good luck and remember to always take care.
  12. When disposing of unwanted lead please take note of your local authority about appropriate methods.


  1. Lead is a toxic material
  2. Use PPE when handing moulds
  3. Use dry moulds as water can cause molten lead to explode


Additional information




zinc alloy, zinc alloy


Lead Sinker

Mould Weight


Roundhead Jig Weight

1oz, 2oz, 3oz, 1.5oz, 2.5oz


1pcs / lot




There are no reviews yet.

Be the first to review “Pyramid Sinker Mould”

Your email address will not be published. Required fields are marked *

    Your Cart
    Your cart is emptyReturn to Shop